Colombia

1.2 layer PCB bard designing.
2. Compliant with PCI express 2.0, 1.1 Specification
3. 1-slot PCI-E 1X to 4 slot 1X riser card with high speed USB 3.0 cable.
4. High speed USB 3.0 shield cable is flexible for 1U,2U,3U chassis.
5. Support 4 port high speed PCIe 1X card.6. Solid  provide extra stable power supply for PCI-e card
Instructions: 
If you need more than one PCI-E x1 slot on the motoard was not any so much, it touches you can think about it. It consists of two parts, one main card, interface
installed via PCI-E X1 on the motoard, two equipment cards, both of which are connected together via USB 3.0 cable.
The device card also uses the United States Pericom Pericom PI7C9X bridge chip, for switching PCI-E, PCI-E between.
But even USB 3.0, but also the theoretical bandwidth 5Gbps (625MB / s), one Into four Then remove the loss would only 150MB / s, and even PCI-E 1.x single-channel
bandwidth also has 250MB / s, So this stuff more than enough to give you the best slots, there will not be enough bandwidth, not only for the performance requirements of the place. Therefore, the transferred PCI-E slot is the best version above 2.0, the 3.0 version is better.
Several Divided PCI-E 1X slot all is gen2 e, even if gen1 previously ,it can be ok.
Specifications:
1. Power Connector: usb 3.0 power cable
2. Mainboard size:(L*W*H)9.70*6.30*1.30cm/3.82 inch*2.48 inch*0.51 inch
3.PCI-E Card size:(L*W*H)11.90*6.60*1.90cm/4.69 inch*2.60 inch*0.75 inch
4.USB cable length 0.6m/1.8ft
Colour:blue
Material:plastic
Package Contents:
1 x 1 to 4 Mining Board Adapter
1 x PCI-E 1X Riser Card
1 x USB 3.0 CableOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.