Vender FYSETC 3Pin Temperature Header PT100 Stick Temperature Sensor al mejor precio

1. FYSETC-PT100Stick is a Pololu formfactor MAX31865 breakboard for FYSETC S6/Spider and similar 32 bit 3D printer control boards. It is base on VORON PT100Stick. 2 .Detailed information access: https://github.com/FYSETC/FYSETC-PT100Stick Klipper configuration: 1. SSH into your RaspberryPi and edit your printer.cfg file using nano. 2. Remove any old thermistor configuration under [extruder]. (sensor_type, sensor_pin, etc.) 3. Under [extruder] add these lines: sensor_type: MAX31865 sensor_pin: PD11 # I pulg into Spider E4-MOT socket, `cs` pin is the sensor pin spi_speed: 4000000 spi_software_sclk_pin: PE12 spi_software_mosi_pin: PE14 spi_software_miso_pin: PE13 rtd_nominal_r: 100 rtd_reference_r: 430 rtd_num_of_wires: 2 4. If you are in EU or any 50 Hz country add this line: rtd_use_50Hz_filter: True 5. Save your changes by typing CTRL+X, Y, [ENTER]. Send FIRMWARE_RESTART from the console in Octoprint and test! It should work. 6. Run PID tuning. PT100 readings will be different from your previous thermistor. For the best thermal accuracy, follow this to PID tune: 1. Heat your bed to 100C. 2. Move your hothend to the center and 5-10 mm above bed 3. Set fans to 25%: "M106 S64" 4. Run: "PID_CALIBRATE HEATER=extruder TARGET=245" 5. This will run for a few minutes. When finished, save with: "SAVE_CONFIG" Colour:black Material:Plastic + Metal Size:20 x 15mm Package Contents: 1 x Temperature SensorOnly the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.