Vender 3D Printer Control Board Kit 2560 R3 Improved Board with Heat Sink al mejor precio
0
calificaciones
200.337 COP
30% OFF
140.236 COP
Se envía desde |
---|
Descripción del producto
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost.
RAMPS interfaces an Ard Mega with the powerful Ard MEGA platform and has plenty room for expansion.
The ular design includes plug in stepper drivers and extruder control electronics on an Ard MEGA shield for easy service, part replacement, upgrade-ability and expansion.
Additionally, a number of Ard expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.
Version 1.4 uses surface mount s and resistors to further cover edge issue.
Operationg Voltage:5V
Input Voltage (recommended):7-12V
Input Voltage(limits):6-20V
Digital I/O Pins :54(of which 14 provide PWM output)
Analong INput Pins :16
DC Current per I/O Pin:40mA
DC Currentfor 3.3 V Pin:50mA
Flash Memory :256 KB of which 4 KB used by bootloader
SRAM :8 KB
RepRap Mega Pololu Shield, or RAMPS for short.
Colour: as shown
Material: PCB
Size: 12x6.5x2cm
Package Contents:
1 * R3 improved motoard
1 * RAMPS 1.4 control board
5 * DRV8825 drivers
5 * Heat sinks
1 * USB cableOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.